Radix epsilon Bedienerhandbuch PDF herunterladen (Seite 21)

Setting Up and Programming the Digital Receiver

Version 1.0 Page 21

7.5.2 Adjusting the DiSEqC-Controller and/or the 22-kHz Control Signal

NOTE:

This adjustment is used for selecting the correct segment of the frequency bands.

The DiSEqC-controller, which may be used only if the satellite system in use is

equipped with a DiSEqC-switch, incorporates the correct settings for all of the

various parameters involved: upper/lower band, horizontal/vertical polarization,

and the type of satellite system involved.

In the event that the satellite system involved is not DiSEqC-controlled, the setting

for “Upper/Lower Band” will have to be manually entered by toggling the “22kHz“

setting ON/OFF.

Most commercially available satellite systems employ so-called “general-purpose”

LNB’s where a setting of “22 kHz ON” will automatically effect a switch to the upper

band, where all digital satellite channels will be found (the factory default setting is

22 kHz ON).

• Use the p and q keys to highlight the “DiSEqC/22kHz“ field.

• Press the MENU-key:

• Use the p and q keys to toggle the “22kHz“ setting ON/OFF

or select the DiSEqC-controller required.

• Press the MENU-key to confirm your choice.

CAUTION:

These settings should be altered by specially trained personnel only.

In order to be able to receive the greatest possible number of channels, you will

have to repeat the automatic-search procedures (cf. Section 7.5.5, below) for each

and every available DiSEqC-setting and for both settings of the 22-kHz control

signal {ON/OFF).

MENU/EXIT

Setup Value

Satellite

Installation

1 - 3 - 2

Signal Strength

DiSEqC/22KHz Auto Search

LNB Lokal-Freq Manual Search

OFF22KHz

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 34 35

Keine Kommentare

Radix epsilon Bedienerhandbuch Seite 21